TEJO
GEN 1
A 7-inch FPV drone you print, build by hand, and upgrade yourself. Every component is modular.
Engineered to be tinkered with.
Each part is shaped for real flight performance — and made to be reprinted, repaired, and reworked at your bench.
3D printed chassis
Printed in PPA-CF or PETG-CF — any high-performance CF-infused filament works with good rigidity.
Bonded carbon arms
DP460 epoxy joints for rigid, precise, crash-resistant alignment.
Modular payload bay
Swap cameras, sensors, and drop mechanisms on a standard mounting interface.
Off-the-shelf electronics
Fits a 30×30 or 20×20 FC and ESC stack, and runs a standard FPV LiPo — nothing proprietary to source.
Build it with us.
Wrestling with a print setting, a cure time, or a stubborn tune? Drop into the Discord — other Tejo builders post their print profiles, swap parts advice, and walk you through whatever's stopping your maiden.
Join the DiscordPrint it.
Build your own.
CAD, slicer profiles, assembly walkthroughs, and firmware presets — the complete set to build, change, and fix the Tejo yourself.